Air Filter - Can-Am SPYDER RT Series 2020 Original Instructions Manual

MAINTENANCE PROCEDURES
When doing...
Engine oil and
engine oil filter
replacement
Engine oil,
engine oil filter
and HCM
surface filter
replacement
23. Reposition the brake fluid reser-
voir.
23.1Install both brke level
switches.
23.2Reinstall the retaining pin at
the back of the reservoir.
23.3Connect the brake switches
connector.
24. Reinsert and completely screw in
the dipstick.
25. Check engine oil level and adjust
if required. Refer to E
L V
EVEL ERIFICATION
NOTICE Ensure oil pressure warning
lamp goes out within 5 seconds from
engine start. If oil pressure warning
lamp stays ON for more than 5 sec-
onds, STOP ENGINE and recheck oil
level.
26. Ensure engine oil filter cover, mag-
netic drain plug (clutch cover) and
drain plug (oil sump cover) are not
leaking.
27. Stop engine.
28. Reinstall the left service cover.
29. Dispose of used oil as per your
local environmental regulations.
118
Quantity
4.7 l
(5.0 qt(liq.,US))
4.9 l
(5.2 qt(liq.,US))
O
NGINE IL
in this section.

Air Filter

Removing the Air Filter
1. Remove the right service cover.
Refer to SERVICE COVERin
EQUIPMENT.
Remove the 3 screws from the air filter
cover.
219002072-072
Remove the air filter cover and the filter.
219002072-073
Inspecting the Air Filter
Inspect air filter for cleanliness and
damage.
NOTICE It is not recommended to
blow compressed air on the paper filter.
This could damage the paper fibers and
reduce its filtration ability when used in
dusty environments.
NOTICE Do not wash the paper filter
with any cleaning solution.
NOTICE Inspect air intake silencer
and remove any dust or debris taking