Dead Battery - Can-Am SPYDER RT Series 2020 Original Instructions Manual

On-road vehicle
Table of Contents

Advertisement

WHAT TO DO IN THE FOLLOWING CIRCUMSTANCES

Dead Battery

If the battery is dead or too low to crank
the engine, it can be jump started.
WARNING
Connect the jumper cables as spec-
ified in the jump start procedure.
Batteries can emit explosive gas
that can ignite if jumper cables are
not properly connected.
NOTICE
Do not disconnect the dis-
charged battery.
1. Park the booster vehicle closed to
the front of your vehicle.
2. Shift vehicle into neutral (N).
3. Open the front storage compart-
ment cover.
4. Remove the battery access panel.
5. Remove the positive terminal
cover and clean corrosion from
battery posts before connecting
the jumper cables.
219002072-090
6. Beginning by connecting one end
of the RED jump lead to the posi-
tive (+) post of the discharged bat-
tery.
7. Connect the other end of the RED
jump lead to the positive (+) post
of the booster vehicle battery.
140
8. Connect one end of the BLACK
jump lead to the negative (-) post
of the discharged battery.
9. Connect the other end of the
BLACK jump lead to the negative
(-) post of the booster vehicle
battery.
10. Start the booster vehicle and let
run to idle.
11. Start your vehicle in the usual way;
if the engine does not start, wait
a few minutes before repeating
the attempt in order to protect the
starter motor and the booster bat-
tery.
Note: If it still does not start, there
might be a problem with the starting
system. Have the vehicle transported
(see T
RANSPORTING THE
this section) and repaired by an au-
thorized Cam-Am On-Road dealer.
12. Once the vehicle has been started,
let run both vehicles to idle for a
few minutes before disconnecting
the jumper cables.
13. Remove the jumper cables in the
reverse order that they were con-
nected.
Note: If the engine dies shortly after it
has been started or when the jumper
cables are disconnected, there might
be a problem with the charging sys-
tem. Have the vehicle transported (see
T
RANSPORTING THE
tion) and repaired by an authorized
Cam-Am On-Road dealer.
14. Have the battery fully recharged
with a battery charger (see
M
AINTENANCE
a qualified service station as soon
as possible,
V
EHICLE
V
) in this sec-
EHICLE
P
) or by
ROCEDURES
) in

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents