Brakes - Can-Am SPYDER RT Series 2020 Original Instructions Manual

your fingers may be caught between
the wheel and the brake caliper.
Tire Registration Form
In the event of a tire recall, we can
only contact you if we have your name
and address. As a vehicle manufac-
turer, BRP keeps a record of the Tire
Identification Number (TIN) associated
with the Vehicle Identification Number
(VIN) (see
VEHICLE IDENTIFICATION
its current owner information.
If you replace any tire on your vehicle, a
"Tire Registration Form" must be com-
pleted and sent to the tire manufacturer
consumer service group.
Registration Form" is available at an
authorized Can-Am On-Road dealer.

Brakes

WARNING
New brakes will not operate at
their maximum efficiency until their
break-in is completed. Braking
performance may be reduced, so
use extra caution. Brakes take
about 300 km (200 mi) of riding with
frequent braking to break-in. For
riding with infrequent braking, allow
extra time to break-in the brakes.
Verifying the Brake Fluid Level
Use only DOT 4 brake fluid from a
sealed container.
Check the brake fluid level as follows:
1. Park the vehicle on a firm, level
surface.
2. Remove the right service cover.
Refer to SERVICE COVERin
EQUIPMENT.
3. Check the brake fluid level in
) and
219002072-086
1.
2.
The "Tire
4. Add fluid as required. Refer to
Note: Low brake fluid may indicate
leaks or worn brake pads.
authorized Can-Am On-Road dealer.
Adding Brake Fluid
1. Clean the filler cap.
Clean filler cap before removing.
Use only DOT 4 brake fluid from a
sealed container.
2. Remove the filler cap.
219002072-077
3. Add fluid to MAX level.
MAINTENANCE PROCEDURES
reservoir.It should be above the
MIN. line.
2
1
Brake fluid MIN. level line
Brake fluid MAX. level line
ADDING BRAKE FLUID.
WARNING
See an
125