Table of Contents
Advertisement
3. 2. 5. 3 Connectors, IF Side of S9101RH mmWave Transceiver
Keysight S9101A 5G Multi-Band Vector Transceiver, Startup Guide
LO/IF Out
Connector
IF In/Out
Connector
IF frequency range
IF input power range
IF output power range
IF In
Connector
IF frequency range
IF input power range
LO/Pwr/Ctrl/IF In
Connector
Frequency range,
LO,
DC power
Do not connect or disconnect the RF cable, at either end, while
the connected instrument is powered on.
3 Review Hardware Components
SMA (f), 50 Ω, nominal
This port provides the IF output of the down-
converter in the S9101RH. This port also accepts
an LO input to be used by the downconverter.
SMA (f), 50 Ω, nominal
This port can be used either to accept an IF input to
the upconverter in the S9101RH or to provide the
IF output of the downconverter in the S9101RH.
2.5 to 4 GHz
–20 to –30 dBm minimum, CW
–24 to –8 dBm, CW
SMA (f), 50 Ω, nominal
This port accepts an IF input to the upconverter in
the S9101RH.
2.5 to 4 GHz
–20 to –30 dBm minimum, CW
SMA (f), 50 Ω, nominal
This port accepts an IF input to the upconverter in
the S9101RH. This port also accepts the following
inputs, which are combined with the IF input signal:
An LO input to be used by the upconverter
and/or downconverter in the S9101RH.
A +36 VDC voltage input to power the
S9101RH.
A control signal to operate the S9101RH.
6 to 12 GHz,
–20 dBm, minimum
+36 VDC, 1A
29
Advertisement
Table of Contents
