Ac Power Cord - Keysight Technologies S9101A Startup Manual

2 Review Safety Requirements

2. 11 AC Power Cord

The S9101A is equipped with three-wire power cords, in accordance with
international safety standards. These power cords ground the S9101A cabinet when
connected to an appropriate power line outlet.
Use the Keysight supplied power cord or one with the same or better electrical rating.
The cable appropriate to the original shipping location is included with the S9101A.
See: http://www.keysight.com/find/powercords
The S9101RH mmWave Transceiver does not have an AC power cord connection. It is
powered by a DC voltage that is supplied over the RF Cable Assembly to the
LO/Pwr/Ctrl/IF In connector. The DC supply does not represent a risk of personal
injury.
14
Always use the three-prong AC power cord supplied with these
products. Failure to ensure adequate earth grounding by not using
these cords can cause product damage.
If these products are not used as specified, the protection
provided by the equipment could be impaired. These products
must be used in a normal condition (in which all means for
protection are intact) only. Install the S9101A so that its
detachable power cord is readily identifiable and easily reached
by the operator. The detachable power cord is the instrument's
disconnecting device. It disconnects the Mains circuits from the
Mains supply before other parts of the instrument. The front panel
switch is only a standby switch and is not a LINE switch.
Alternatively, an externally installed switch or circuit breaker
(which is readily identifiable and is easily reached by the operator)
may be used as a disconnecting device.
Keysight S9101A 5G Multi-Band Vector Transceiver, Startup Guide