REMKO Easy-Control EC1 Operating And Installation Instructions page 14

REMKO remote controls
Access to the expert level
In order to access the expert level, the Easy-Control remote control must be deactivated with the " " key.
Once the remote control has been deactivated, press the "M" key and " " key at the same time for approx.
five seconds.
The expert level is now released and starts with the parameter "1" from the following table.
With the "M" key you can now display the individual parameters in order.
Change the parameters using the arrow keys " " and " ".
Parameter Function
Correction of the
1
room temperature
2 Switching hysteresis
3 Key lock
4 Probe type
5 Min. temperature
6 Max. temperature
7 Time 12/24 hrs.
8 Temperature display
Max. room set tem-
9
perature
Min. room set temper-
A
ature
b Display brightness
c BUS address
d Band
After the settings are entered, it is not necessary to save the parameters. The data is accepted automatically.
14
Value range
"-9 °C - + 9 °C
"1 °C - 5 °C"
0: Key lock apart from
"on / off"
1: All keys locked
In: Internal probe of
the remote control
Ex: External probe
AL: Internal and
external probe
"+5 °C - +15 °C"
"+15 °C - +45 °C"
0: 12 hrs
1: 24 hrs
0: measured room
temperature
1: Room target tem-
perature
"25 °C - 70 °C"
"0 °C - 10 °C"
Display brightness in
stand-by mode
"01 - 99"
"01 - 06"
Factory setting
"-2 °C"
"1 °C"
1
AL
5 °C
35 °C
1
0
45 °C
10 °C
0 (dark) - 99 (light)
1
1
User settings
Factory setting
Factory setting