Toshiba B-SX6T Series Owner's Manual page 41

2. PRINTER SETUP
2.8.1 Parameter Setting
(Cont.)
When "CODE MANUAL" is selected and the [PAUSE] key is pressed,
the LCD display will show the setting screen of CONTROL CODE1 to
CONTROL CODE3 as follows.
<2>PARAMETER SET
CONTROL CODE1 1B
[RESTART]
[FEED]
After setting the control code for Control Code 1, press the [PAUSE]
key to show the CONTROL CODE2 screen. In a same manner, press the
[PAUSE] key after setting the control code for Control Code 2 to display
the CONTROL CODE3 screen.
CONTROL CODE1
[PAUSE]
CONTROL CODE2
[PAUSE]
CONTROL CODE3
Press the [PAUSE] key after setting the control code for Control Code 3.
(13) Ribbon Type Selection
This parameter is to choose a ribbon type to be used.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
RIBBON TRANS
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting a ribbon type, press the [PAUSE] key.
E2-27
ENGLISH VERSION EO1-33056
2.8 Setting an Operating Environment
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 FD
CONTROL CODE1 02
CONTROL CODE1 01
CONTROL CODE1 00
RIBBON TRANS
RIBBON NON TRANS
Transparent ribbon
Non transparent
ribbon