Toshiba B-SX6T Series Owner's Manual page 20

2. PRINTER SETUP
2.4 Loading the Media
(Cont.)
WARNING!
Be careful not to pinch your
fingers or hands by the Supply
Holder Frame or Media
Holders when loading the
media.
NOTE:
Place the bushes of the Supply Shaft
into the notches of the Supply
Holder Frame securely.
Notch
9.
Loosen the Media Guide Screws on the printer back, and move the
Media Guides outside.
Media Guide Screw
10. Place the assembled Media Holder onto the Supply Holder Frame, and
feed the media between the two Media Guides.
Turn the Locking Lever of the Media Holder to the "Open" position,
and push the Media Holders toward the centre to place the media at the
centre on the Supply Shaft. Then, lock the position of the media by
returning the Locking Levers to the "Close" position.
Bush
Close
11. Feed the media until it extends past the Platen.
12. Move the Media Guides inside, causing the media to be automatically
centred. Then, tighten the Media Guide Screws to secure the Media
Guides.
Media Guide
Media Guide Screw
Media Guide
Supply Holder Frame
Media Holder
Open
Media Holder Frame
E2- 6
ENGLISH VERSION EO1-33056
2.4 Loading the Media
Media