Toshiba B-SX6T Series Owner's Manual page 44

2. PRINTER SETUP
2.8.1 Parameter Setting
(Cont.)
NOTES:
1. It is recommended that this
function should be activated when
high quality printing such as bar
codes printing is required.
Otherwise, choose OFF.
2. When a broken element is found,
the printer stops, displaying
"HEAD ERROR". The error
state can be cleared by pressing
the [RESTART] key, but if the
broken element affects bar code
readability or actual operations,
please replace the print head with
a proper one.
(18) Auto Print Head Check Selection
This parameter is to choose whether to perform the Auto Print Head
Check function at the power on time. When "<2>PARAMETER SET"
appears, press the [PAUSE] key until the following display appears.
<2>PARAMETER SET
AUTO HD CHK OFF
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting auto print head check, press the [PAUSE] key.
(19) Centronics Interface ACK/BUSY Timing Selection
This parameter is to choose an ACK/BUSY timing of the Centronics
interface.
"TYPE1" has been chosen as default, but if a communication error occurs
or a communication is not properly made, change to "TYPE2".
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears".
<2>PARAMETER SET
ACK/BUSY TYPE1
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting an ACK/BUSY timing, press the [PAUSE] key.
E2-30
ENGLISH VERSION EO1-33056
2.8 Setting an Operating Environment
AUTO HD CHK OFF
Auto print head broken element
check is not performed.
AUTO HD CHK ON
Auto print head broken element
check is performed.
ACK/BUSY TYPE1
A rise of ACK signal and a release of
BUSY occur at the same time.
ACK/BUSY TYPE2
A fall of ACK signal and a release of
BUSY occur at the same time.