The Pool Factory Saltwater Aurora Installation Manual page 54

Section
4
1. Finish filling the pool
a. Fill the pool with water to 2" (5cm) below the lowest
opening. Make sure you remove any creases from the
liner in the bottom of the pool before the water level gets
too high.
b. While the pool is filling, remove the nails that were hold-
ing the bottom rails in place.
c. Your pool is now installed. You must now install the filter
and pump, the skimmer and water return inlet. Please
follow the installation instructions that come with these
products.
IMPORTANT:
Make sure that your pool is round, do not assume that by filling up the pool that this will help the pool to place itself
into a perfect round circle. Ensure that it is round before filling up the pool with water.
IMPORTANT SAFETY INFORMATION:
Please refer to the safety page at the beginning of this instruction manual. You must follow the rules and information
regarding placement of safety stickers on your pool.
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING THE POOL FRAME
D. FILL YOUR POOL WITH WATER
No Diving or Jumping. Observe all Safety Rules
Page 54
Section 4