Section
1
1. Mark out the area
a.
The next following steps will show you how to mark out
the area you need for the oval pool. This marked area
will be larger than the pool size itself, but this space is
needed. Find a site where the ground is stable, level
and well drained. Once you have selected your site,
determine where the middle of your pool will be.
See Diagrams:
Please see in the next page for an EXAMPLE on how to
correctly mark your pool area.
Please verify your pool's FOOTPRINT for correct
measurements on the last pages of this Section 1.
b.
Drive a peg into the ground at the centre point.
(Image 1)
c.
Now you must make the round ends that will be the oval
part. In order to do so, you will have to determine the
center of the radius on each side and drive a peg into the
ground. (Image 2)
d.
Using a length of string tied between the peg and a can
of spray paint mark the circles on the ground. (Image 3)
e.
Once the center has been established, and the
measurement of the pool itself has been determinded,
you must now determine the outer limits of the perimeter
of your pool. Add 12" (30cm) outside this measurement
to determine pool perimeter. (Image 4)
Section 1
GENERAL INSTRUCTIONS - OVAL POOLS
GROUND PREPARATION
B. PREPARE THE FOUNDATION OF YOUR POOL
No Diving or Jumping. Observe all Safety Rules
1
2
3
4
Page 14
Need help?
Do you have a question about the Saltwater Aurora and is the answer not in the manual?