The Pool Factory Saltwater Aurora Installation Manual page 44

Section
3
c. Now that you have installed the wall you can be faced
with three scenarios.
1) The wall joints align perfectly, if so, move on to the
next step (c).
2) Your wall appears to be too short. It is not. However
the space between the bottom rails must be decreased
by lightly tapping the bottom plates towards the inside
of the pool. You can also tap the wall lightly with both
hands in the desired direction. (Image 8)
You MUST recheck the gaps at each and every one of
the bottom rails so that they are all equal in gap size.
3) Your wall appears too long. It is not. However the
space between the bottom rails must be increased by
tapping the bottom plates lightly towards the outside of
the pool or by tapping the wall with both hands in the
desired direction. (Image 9)
You MUST recheck the gaps at each and every one of
the bottom rails so that they are all equal in gap size.
Important Note:
Bottom rails must always be held in place in the bottom
plate.
Important Note:
You MUST recheck the gaps at each and every one of the
bottom rails so that they are all equal in gap size.
d. Adjusting the pool to the proper shape may cause the
bottom rails and bottom plates to slip out of alignment a
little. Recheck all of the bottom plates to make sure each
one is centred where the bottom rails meet.
e. Cover the entire joint and bolts with duct tape on the
interior of the wall. This will protect the liner from any
punctures. (Image 10)
Section 3
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING THE POOL WALL
A. CONT. SETTING UP THE POOL WALL
No Diving or Jumping. Observe all Safety Rules
8
9
10
Page 44