The Pool Factory Saltwater Aurora Installation Manual page 41

Section
3
Do not attempt to install the pool wall in the wind, wait for a calm day.
1. Preparing for the wall installation
a. Bring the following items into the middle of the pool
foundation before you start uncoiling the pool wall:
plywood, some extra sand or fine dirt to make the cove
and a ladder to climb out after the wall is assembled.
b. Make sure the skimmer and water return holes are
located where you need them to be. The skimmer and
water return holes are positioned towards the end of the
wall, (the section before where the wall started).
Important Note:
Wall edges could have exposed fibres or be sharp, it
is important to wear gloves when installing.
2. Set the pool wall in place
a. Unpackage the pool wall and stand it on the plywood at
the place close to where you need to install the skimmer.
(Image 1)
(Remember the skimmer and water return holes will be
placed at the section just before where you started the
wall installation).
b. Start unrolling the wall, guiding the bottom edge into
the curved bottom rail. The starting end of the wall must
be positioned in the center of a bottom plate, and the
skimmer and return holes should be positioned where the
pump and filter will be. (Image 2)
Important Note:
It is preferable to use very fine sand that is easily
compacted. Be careful not to spill sand on the bottom rails.
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING THE POOL WALL
A. SETTING UP THE POOL WALL
It takes at least 3 people to install the pool wall.
No Diving or Jumping. Observe all Safety Rules
1
Important Note:
Unlike the steel wall, the resin does not have
corrugation. The resin wall is very strong once fully
installed, but during installation the wall can be softer
and easily damaged depending on the weather.
Special care must be taken.
2
Page 41
Section 3