The Pool Factory Saltwater Aurora Installation Manual page 43

Section
3
3. Join the ends of the pool wall
Your resin wall has a different wall joint than the regular
steel wall.
IT IS VERY IMPORTANT TO FOLLOW THESE
INSTRUCTIONS:
a. All holes must be used. If screws are missing, please
contact your customer service and they will send you
missing screws. (Images 5 & 6)
b. Each wall end has a extra bonded thickness. Attach wall
ends with the two wall bars. Both must be used, one on
the interior and one for the exterior of the wall.
(Image 7)
Important Note:
Stick a screwdriver through two of the holes to help line
up the ends of the wall.
When tightening the screws start from either the
top and go down or vice versa. Do not start a few
screws from top and a few from the bottom to meet
in the middle, this can cause problems later on.
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING THE POOL WALL
A. CONT. SETTING UP THE POOL WALL
No Diving or Jumping. Observe all Safety Rules
Exterior
5
Exterior
6
Extra thickness
wall end
Extra thickness
wall end
7
Page 43
Extra thickness
wall end
Interior
Exterior
Interior
Interior
Wall bar
Wall bar
Section 3