Siemens SENTRON 7KN POWERCENTER 3000 Manual page 96

Glossary
S.M.A.R.T
Self-Monitoring, Analysis and Reporting Technology (SMART or S.M.A.R.T.) is an industry
standard that is incorporated in storage media. It enables permanent monitoring of important
parameters and therefore early detection of incipient faults.
SATA
Serial ATA. An interface for hard disk drives and optical disk drives with serial data
transmission.
SETUP (BIOS setup)
A program with which information is defined about the device setup (that is the expansion
level of the hardware of the PC/PG). The device setup of the PC/PG is preset. Changes then
have to be made when a memory expansion, new modules or drives are to be activated.
Setup files
They contain data that define what the setup will look like after restart. Such files are, for
example, CONFIG.SYS, AUTOEXEC.BAT, and registration files.
Setup software
With the setup software, the device setup is updated when modules are installed. This is
done either by copying the setup files supplied or by manual setup.
SSD
A Solid State Drive is a drive that can be installed like a conventional hard disk but does not
contain a rotating disk or any other moving parts because only semiconductor modules with
similar capacity are used. The advantages are robustness, short access times, low energy
consumption and fast data transmission.
STEP 7
Programming software for generating user programs for SIMATIC S7 control systems.
Wake on LAN
Wake on Local area network. With this function, the PC can be started via the LAN interface.
Warm restart
A warm restart is understood as a restart after program termination. The operating system is
reloaded and started again. A warm restart is performed with the hotkey CTRL + ALT+ DEL.
94
7KN POWERCENTER 3000
Manual, 10/2019, L1V30579222003-01