Mounting On Din Rails - Siemens SENTRON 7KN POWERCENTER 3000 Manual

Procedure – mounting
4.1.3.4

Mounting on DIN rails

The standard rail mounting is suitable for horizontal and vertical mounting of the device.
Requirements
● A SIEMENS 35-mm DIN rail TH35-15 according to EN 60715:2001
The DIN rail is mounted.
● A DIN rail clip
Note
Use only the screws supplied to mount the DIN rail clip. Longer screws can damage the
interior of the device
Tools
● A T10 screwdriver
7KN POWERCENTER 3000
Manual, 10/2019, L1V30579222003-01
Installing, connecting, commissioning
1. Mark out the mounting holes on the mounting sur-
face.
2. Drill the mounting holes.
3. Place the wall plugs in the drill holes.
4. Place the mounting bracket on the rear of the de-
vice. Pay attention to the orientation of the keyhole
drill holes of the mounting bracket.
5. Fasten the mounting bracket with the 4 screws
supplied.
6. Place the device with the mounting bracket onto
the mounting surface.
7. Screw the device on.
4.1 Preparing installation
25