Interfaces Of The 7Kn Powercenter 3000; Internal Ethernet Interface For The Smart Assembly Network - Siemens SENTRON 7KN POWERCENTER 3000 Manual

Installing, connecting, commissioning

4.6 Interfaces of the 7KN POWERCENTER 3000

Procedure - switching the device off
7KN Powercenter 3000 can be switched off with the ON/OFF switch (see chapter Design of
the devices (Page 14)) using a narrow object, e.g. a screwdriver.
1. Press briefly (less than one second) to shut down the device. This can take less than one
minute
→ The LED "PC ON/WD" lights up yellow.
2. Press for longer than 5 seconds to switch off the device (Power-OFF).
→ The LED "PC ON/WD" lights up yellow. The power supply can now be disconnected.
Alternatively, brief repeated pressing causes a restart of the 7KN Powercenter 3000.
3. Press briefly 5 times until the LED "PC ON/WD" flashes green / yellow. This resets to
device to the delivery condition. 7KN Powercenter 3000 has to be commissioned again.
Further information
If the 7KN Powercenter 3000 is disconnected from the power supply, the current processing
status is backed up, if possible.
The time continues to be kept during the power failure for as long as the battery remains
active.
4.6 Interfaces of the 7KN POWERCENTER 3000
7KN Powercenter 3000 provides separate interfaces for external and internal
communication, having different communication options. These are explained below.
4.6.1

Internal Ethernet interface for the smart assembly network

Benefits: Through this interface, the SENTRON devices of a smart switchgear assembly (=
smart assembly) are connected via Ethernet to a 7KN Powercenter 3000.
For example:
● PAC3200
● PAC4200
● PAC3100
● 3WL via COM16
● 3VA via COM100 / COM800
● 3WL via COM35
● powerconfig (optional)
● Web user interface, e.g. HMI Panel. The default IP address on X2P1 is: 192.168.1.2
You will find further devices in the ReadMe
(https://support.industry.siemens.com/cs/ww/en/view/109762951) of the firmware update.
34
7KN POWERCENTER 3000
Manual, 10/2019, L1V30579222003-01