Siemens SENTRON 7KN POWERCENTER 3000 Manual page 22

Installing, connecting, commissioning
4.1 Preparing installation
6. If the package contents are incomplete, damaged, or not exactly what was ordered,
inform the responsible delivery service immediately.
7. Also keep the supplied documentation in a safe place. It forms part of the device. When
you commission the device for the first time, you will require the documentation.
8. Note the identification data of the device.
20
NOTICE
Damaged device
• Ensure that the damaged device is not erroneously installed and commissioned.
• Label the damaged device and keep it locked away.
• Send the device for repair immediately.
NOTICE
Damage due to condensation
If the device has been exposed to low temperatures or extreme temperature fluctuations
during transportation, e.g. in cold weather, moisture may have condensed on or in the
device (condensation).
Moisture causes short-circuits in electrical circuits and damages the device.
To avoid damage, proceed as follows:
• Store the device in a dry place.
• Equalize the temperature of the device with room temperature before starting it up.
• Do not expose the device to the direct radiated heat of a heater.
• In the event of condensation, only switch on the device when it has completely dried
or after a delay of approx. 12 hours.
7KN POWERCENTER 3000
Manual, 10/2019, L1V30579222003-01