Page 2
W irele s s R e ce iv e r S E T S Y N C S E T S Y N C SDR-6220 / 6120 receiver two transmitters a pair of antennas (handheld / belt-pack) audio cable switching adaptor operation manual ** Remark: The above specifications are subject to change without prior notice.
Page 3
Instructions Parts and functions Power switch 0 0 1 0 0 1 CH 1 630 000 630 000 CH 2 FREQ FREQ SDR-6120 Wireless Receiver SYNC SYNC IrDA synchronization button SET button IR sensor area UP button DOWN button Antenna A (TNC) DC input CH-1 unbalanced audio output CH-1 balanced audio output...
SDR-6220/6120 UHF Dual-Channel 2-Way Sync True Diversity Receiver CHANNEL scanning For an interference- free operation, a cleaner channel might be necessary if the current one receives too much interference. To operate the scanning: Press SET button to make the frequency icon appear on the bottom.
Page 5
Instructions Changing the receiver’s channel Press the synchronizing button of the transmitter. The transmitter's LED will grow to denote synchronizing signal transmitted. The channel/frequency of the receiver will change and then the synchronization is complete. Changing the transmitter’s channel 0 0 1 0 0 1 630 000 630 000...
SDR-6220/6120 UHF Dual-Channel 2-Way Sync True Diversity Receiver If this still does not solve the problem it means this frequency is not suitable. Adjust the squelch back to its preset level and use the scan function to locate a clear, interference-free channel.
Instructions Audio output connection Balanced output: XLR connector provides balanced audio output signal from this jack to the mixer/amplifier. Use an audio output cable with “XLR” or “Cannon” connector, connect one end to the balanced output jack of the receiver, and the other end to the “MIC IN” jack of the mixer/ amplifier.
Need help?
Do you have a question about the SDR-6220 and is the answer not in the manual?
Questions and answers