Assembly Step 1: Burner Chamber Installation - Weston 41-0701-W Manual

ASSEMBLY STEP 1: BURNER CHAMBER INSTALLATION

TOOLS NEEDED
LOCATE THESE PARTS
PHILLIPS
BURNER
CABINET
HEAD
CHAMBER
ASSEMBLY
SCREWDRIVER
ASSEMBLY
A1
HARDWARE BAG
HARDWARE
7/16"
WRENCH
3 NUTS
3 BOLTS
READ ALL OF THE INSTRUCTIONS
THOROUGHLY, PRIOR TO ASSEMBLY!
FIGURE 1
1. With the Cabinet in the upright position, begin
by removing the Door Panel from the Cabinet
Assembly by lifting it from the hinges. Set the
Door Panel aside. FIGURE 1
2. Set the Cabinet Assembly top side down. To
prevent scratching or damaging your smoker,
set the Cabinet on a padded surface such as
cardboard or carpet. The top of the Cabinet
has the vent holes; the bottom has mounting
holes for the Legs.
VENTURI
3. Insert the Burner Chamber Assembly upside
TUBE
down through the bottom of the Cabinet as
FIGURE 2
OPENING
shown.FIGURE 2 Be sure the front mounting
tab and Venturi Tube opening is facing the
front of the Cabinet.
4. Line up the bolt holes and insert the Bolts from
the inside of the Cabinet as shown. Loosely
BURNER
thread on the Nuts to hold the assembly in
CHAMBER
place. At this time, DO NOT tighten the Bolts
ASSEMBLY
completely. FIGURE 2
CABINET
ASSEMBLY
TOP
6