Appendix C: Kmmled156 Console Tray Assembly Maintenance - Vertiv KMMLED156 Installer/User Manual

Appendix C: KMMLED156 Console Tray Assembly Maintenance

The USB keyboard, KMMLED156 console, slide tray and slide rail assemblies, can be removed and replaced, if necessary.
These instructions and video cable replacement instructions are provided in this appendix.
C.1 Replacing the USB keyboard (DKMMLED156)
The keyboard is located by opening the console display. Access to release the keyboard is under the slide tray assembly.
Figure C.1 Keyboard Removal
Table C.1 USB Keyboard Tray Access
ITEM DESCRIPTION
1 USB keyboard access
2 USB connector
To remove the USB keyboard from the KMMLED156 console:
1. Fully extend the KMMLED156 tray forward and open the console display.
2. Find the opening, push up to release it and lift the keyboard from the console tray.
3. Disconnect the keyboard from the attached USB cable.
4. If replacing only the keyboard, proceed to the following keyboard installation procedure.
-or-
If replacing the console, tray or rails, proceed to the applicable procedures in this appendix.
To install the USB keyboard into the KMMLED156 console:
1. Connect the USB cable from the keyboard to the console.
2. Angle the rear of the keyboard into the console keyboard tray and push the keyboard into position.
Vertiv | KMMLED156 Rack Mount 15.6" Console Tray for Dell EMC Installer/User Guide | 19