Subscribing A Handset To A Butler 1000, 1010, 1210, 2405, 2410, 2450, 2455 Base Unit - Topcom BUTLER 2455 User Manual

HANDL. B2455_euro.qxd
Butler 2455
• 'NEW CODE' appears on the display.
• Enter the new PIN code in. Use the number keys.
• Press the Programming key
• 'AGAIN' appears on the display.
• Enter the new PIN code again. Use the number keys.
• Press the Programming key
• You hear a confirmation tone. The new PIN code has been set.
Caution : Do not forget your personal PIN code. If you do, you have to restore the default settings
(reset – see section 4.32).
4.24 Subscribing a handset to a Butler 1000, 1010, 1210, 2405, 2410, 2450, 2455
base unit
In order to be able to make and receive telephone calls, a new handset has to be subscribed to
the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is sub-
scribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a Butler 1000, 1010, 1210, 2405, 2410, 2450,
2455 handset and base unit!!
Keep the Paging key
on the base unit begins to blink rapidly. The Line/Charge indicator
for one minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a
number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit
number. It is best to use '1' .
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds when the handset has found the base unit.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit in (default PIN code is '0000'). Use the number
keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
27/2/03 9:01 pm
.
.
on the base unit pressed for 10 seconds until the Line/Charge indicator
.
repeatedly until 'BASE SUB' appears on the display.
.
appears on the display.
.
.
20 20 20 20 20 20 20 20 20 20 20 20 20
Page 20
will blink rapidly