Mounting; Cabling - PESA Jaguar Audio Manual

Jaguar Audio

2.5 Mounting

2.6 Cabling

2
INSTALLATION
page 2.4
Installation
Both the analog and digital models of the Jaguar Audio Routing Switcher
are rack mountable in a standard 19" equipment rack. Sufficient space
must be provided behind the equipment racks to allow for the control
cables, signal cables, and power cables. All mounting holes should be
utilized and mounting hardware tightened securely. As with all equipment
installed in a rack, the bottom screw on each side should be installed
before proceeding with the remainder of the screws. Then all screws
should be securely tightened. Support the Jaguar Audio Routing
Switcher's bottom while installing it in the rack.
To install a Jaguar Audio Routing Switcher in an equipment rack follow
these steps:
1. Align the frame with the slotted opening in the rack.
2. Install the bottom screws first.
3. Install the two top screws
4. Install the other four screws in their allocated positions.
5. Tighten all of the screws until they are secure.
Considerable weight will be added to the rear panel of the Jaguar Audio
Routing Switchers by the control, signal, and power cables. Therefore, all
cables should be strain relieved and secured to racks or other supporting
structures. Failure to provide adequate cable support can result in cables
separating from connectors.
If cable runs are to be stored under an elevated floor, they should be tied
to the racks as a guide. If cables are run along the floor, do not allow them
to lay in the work area behind the racks. Stepping or tripping on the cables
may result in connections being pulled free or wire breakage inside the
insulation. The Jaguar Audio Routing Switcher should be installed in the
equipment rack prior to attaching cables.
Use the following rules when cabling the Jaguar Audio Routing Switcher:
Section 2
3/98
P/N 81905903730