Advertisement
The AV receiver settings are
described in further detail
on page 9.
8
· Kompakt 30
Connections on the AV receiver
Connecting the satellite speakers
Cut up the stock speaker
cable suplied with the loud-
speaker set into suitable
lengths. Remove the plas-
tic sleeving at the speaker
cable ends as shown. Both the speaker cabinets
and the amplifier have speaker terminals marked
[+] and [-]. The [+] pole of the speaker cabling is
marked by a line. Make sure that the connections
on your speakers match the polarity of the ampli-
fier outputs: always connect the plus pole of the
speaker to the plus pole of the amplifier, and cor-
respondingly the minus pole of the speaker to the
minus pole of the amplifier. Out-of-phase cabling
can cause a reduced sound quality, weak bass
response and inferior stereo imaging. In multi-
channel surround systems, it is vital to connect
all of the loudspeakers with the correct polarity
in order to guarantee a fully spatial surround field
and the intended directionality of each channel.
Connect the individual speakers to their respec-
tive speaker terminals on the rear panel of your
AV receiver, i.e., the left front speaker to FL, the
left rear speaker to RL, etc.
Connecting the subwoofer
Connect the subwoofer output of your AV re-
ceiver to the right Line Input (R) of the K 300
SW subwoofer using a mono cinch cable. In this
setup, the subwoofer's left input (Line Input L) is
not connected.
AV RECEIVER
sub
out
Front speAker
+
SEnD
leFt
Front speAker
+
SEnD
right
reAr speAker
+
SEnD
leFt
reAr speAker
+
SEnD
right
centre
+
SEnD
Front
_
+
leFt
_
Front
+
right
reAr
_
+
leFt
reAr
_
+
right
_
centre
+
AV receiVer speAker output
SUBWOOfER KOMpAKt 30
line input
R
L
Advertisement
