Connections - Teufel Theater 1 Technical Specifications And Operating Manual

You can connect the Theater 1 system to any
modern Dolby Digital/DTS 5.1/6.1/7.1 AV re-
ceiver/amplifier for a 5.1 setup with an active
subwoofer. If your receiver is 5.1, connect the
front, centre and rear speakers as shown in the
diagram. If your AV receiver is 6.1/7.1, simply ig-
nore the Rear Centre Out(s). To make full use
of a 7.1 AV receiver, you will additionally need
to install the Theater 1 "5.1 ĕ 7.1 EX" set (see
page 7), which consists of two add-on M 120 D
speakers for the left and right rear centre chan-
nels.
Connect the subwoofer output (Sub Out) of your
Dolby Digital/DTS AV receiver/amplifier to the
right Line Input (R) of the subwoofer using a mono
cinch cable. In this setup, the left input (Line In-
put L) is not connected. If you want to feed the
Sub Out signal to both of the subwoofer's inputs
for an additional bass boost, use a Y adapter (see
Accessories, p. 7).
Connecting
the speakers
to an AV surround
receiver (example:
5.1 system)
Note:
With the 7.1 EX set, connect
the additional L/R rear centre
speakers to the 7.1 AV receiver's
L/R Rear Centre Outs.
12 Teufel · Theater 1

Connections

Front, centre and rear speakers
AV receiver
Speaker output
Subwoofer
Cinch line output Cinch line input
SW Out Input R
AV receiver
Teufel
connection panel
Subwoofer