Connections - Teufel system 4 Operating Manual

You can connect your System 4 loudspeaker set
to any modern Dolby Digital/DTS 5.1/6.1/7.1 AV
receiver/amplifier for a 5.1 setup with an active
subwoofer. If your AV receiver is 6.1/7.1, simply ig-
nore the Rear Centre Out(s). To make full use of a
7.1 AV receiver, you will additionally need to install
the "5.1 ĕ 7.1 EX" set (see page 7), which consists
of two add-on M 450 D speakers for the left and
right rear centre channels.
If you are using a 5.1 AV receiver, connect the
front, centre and rear speakers as shown in the
diagram.
Connect the subwoofer output (Sub Out) of your
Dolby Digital/DTS AV receiver/amplifier to the
right Line Input (R) of the subwoofer using a
mono RCA cable. In this setup, the left input (Line
Input L) is not connected. If you want to feed the
Sub Out signal to both of the subwoofer's inputs
for an additional bass boost, use a Y adapter (see
Accessories, p. 7).
Connecting
the speakers
to an AV surround
receiver (example:
5.1 Cinema Set)
Note:
With the expanded 7.1 set,
connect the additional
L/R rear centre speakers
to the 7.1 AV receiver's
L/R Rear Centre Outs.
12
· System 4

Connections

M 450 FCR
front speaker
left
Subwoofer RCA
line input
Mono RCA cable
M 450 D
Rear speaker
left
AV receiver
Speaker output
AV receiver
M 450 FCR centre speaker
Speaker cable
M 4500 SW
Sub Out
Center
+ -
-
Front left
+
Controller
Surround receiver or AV-receiver
Rear left
- +
Front, centre and rear speakers
Teufel
connection
panel
Subwoofer
RCA line output RCA line input
SW Out Input R
M 450 FCR
front speaker
right
+
Front right
-
Rear right
- +
M 450 D
Rear speaker
right
Subwoofer