Is There Something Wrong With Your Cooker?
Replacing the Oven
Lamp (Both ovens)
Fault Finding Guide
Problem
Nothing Works.
Large oven does not work.
Small oven working OK!
Timer is flashing '000' and
'Auto'
Timer bleeping continually
Ceramic hotplate keeps
switching on/off repeatedly
If the oven lamp fails you can replace it yourself by following these few
instructions.
WARNING! Switch off the cooker at the mains supply before attempting to
replace the oven lamp.
Remove the oven shelves. Unscrew and remove the lamp cover glass.
Unscrew the lamp and replace it with a new 15W S.E.S. lamp.
These are the only lamps suitable for use in your cooker.
Replace the lamp cover glass before switching on.
Note: The oven lamp is not covered by the guarantee.
For a replacement call our Spares Department on 0151 4327910
Before contacting your Belling Service Center/Installer, check the problem guide
below; there may be nothing wrong with your cooker.
Check
Is the main cooker wall switch turned on?
Is the timer working? If the timer is not working it is likely that there is no
electricity supply to your cooker.
Ensure timer is set to manual.
not been activated. (Refer to 'Timer Instructions' pages 12-15 )
Ensure the multifunction control is set to the required position.
The electricity supply has been interrupted and the timer must be reset.
Press button marked "
There is nothing wrong. This is normal operation.
32
Ensure the "Key lock" safety feature has
" to cancel.