Keysight Technologies DAQ970A Programming Manual page 295

Standard Operation Register
Bit num- Bit name
ber
0 Calibrating
1 Self Test
2 Digitizing
(for DAQM909A Digitizer module)
3 Waiting For Trigger
(for DAQM909A Digitizer module)
4 Scanning
5 Waiting For Trigger
(for Scan/DMM Digitize mode)
6 Not Used
7 USB MSD detected
8 Configuration Changed
9 Reading Memory Threshold
10 Instrument Locked
11 Settings Changed
12 Not Used
13 Global Error
14 Not Used
15 Not Used
Keysight DAQ970A/DAQ973A Programming Guide
Decimal value Definition
1 The instrument is calibrating.
2 The instrument is doing a self-test.
4 One or more digitizer channels have been initiated for digitizing.
8 All initiated digitizer channels are in "wait-for-trigger" state.
16 The instrument is scanning.
32 The instrument is waiting for a trigger.
64 (Always returns 0)
128 A USB mass storage device (USB drive) has been detected.
256 The instrument configuration has changed via front panel since the
last INIT, READ? or MEASure?.
512 The number of readings in memory has exceeded the memory
threshold setting (
command)
1024 The instrument is locked (
2048 The instrument configuration has changed via front panel or SCPI
since the last INIT, READ? or MEASure?. Event only, condition
register returns 0.
4096 (Always returns 0)
8192 An error is in the global error queue.
16384 (Always returns 0)
32768 (Always returns 0)
2 SCPI Programming
DATA:POINts:EVENt:THReshold
SYSTem:LOCK command)
295