Advertisement
Quick Links
Advertisement
Related Manuals for Sub-Zero 200 Series
Summary of Contents for Sub-Zero 200 Series
- Page 1 2 0 0 S E R I E S I N S T A L L A T I O N G U I D E...
-
Page 2: Installation
2 0 0 S E R I E S I N S T A L L A T I O N G U I D E... - Page 3 I N S T A L L A T I O N G U I D E Before you begin your installation of a Sub-Zero 200 Series Second, make sure that the actual equipment that was unit, there are a few things you should take special care to shipped to you matches the design you are expecting to observe.
- Page 4 First, make sure that the opening where the R O U G H - I N R E Q U I R E M E N T S Sub-Zero is to be installed is properly prepared. Refer to the Pre-Installation Specifications illustrations and chart to be sure the space dimensions, electrical service and plumbing are correct for the model you are about to install.
- Page 5 2 0 0 S E R I E S P R E - I N S T A L L A T I O N S P E C I F I C A T I O N S Finished Rough Finished Rough Opening Width (A) Opening Height (B)
- Page 6 You will need a 115 volt, 60 Hertz electrical supply. Dedicate Good water is important for good ice quality. It is not rec- a separate 15 amp fuse or circuit breaker to the Sub-Zero ommended that the ice maker be connected to a softened unit, and follow any local codes that apply.
- Page 7 2 0 0 S E R I E S I C E M A K E R O P E R A T I O N : U N P A C K I N G T H E S U B - Z E R O After the water has been hooked up to the icemaker, lower Step 5: Unpack the unit, remove the unit shipping carton.
- Page 8 2 0 0 S E R I E S C O M P L E T I N G T H E I N S T A L L A T I O N CAUTION Step 9: Now, level the unit. Adjust both the front and rear Protect any finished flooring before moving the unit in levelers by turning the levelers clockwise - to raise the unit, place.
- Page 9 Check the location of offset when you’re using specific rout- panels for finger clearance under handle. ing for the grip area only. Refer to the 200 Series section of the Sub-Zero Design Guide for additional information. 3) With panel in position, replace handle. Replace and tight- en all screws.
- Page 10 Model 245: Hinges are factory set; no field adjustment provided for. (See Illustration 5). Model 249 Series: Can be ordered either as a right-hand or left-hand product. Contact Sub-Zero dealer if swing change kit is required. Illus. 5 Illus.
- Page 11 That's it. You've completed the installation of a Sub-Zero If you need service, check the model and serial number on 200 Series refrigerator / freezer. But you're not finished yet. the plate at the top frame of the unit inside the door.
- Page 12 2 0 0 S E R I E S S U B - Z E R O F R E E Z E R C O M P A N Y , I N C . 4717 Hammersley Road • Madison, Wisconsin 53711 (800) 222-7820 •...