Advertisement
C O M P L E T I N G T H E I N S T A L L A T I O N
CAUTION
Protect any finished flooring before moving the unit in
place. If for any reason the unit has been laid on its
back or side, for over a hour, you must allow the unit
to stand upright for a minimum of 24 hours before con-
necting power.
Step 8:
To complete the installation, first shut off power
to the wall outlet. Plug into a 15 amp grounded outlet
and roll the unit into position. Now you have to connect the
ice maker water line (if applicable). Remove the 1/4" com-
pression fitting from its plastic bag and join the water sup-
ply line to the solenoid valve.
IMPORTANT NOTE: Make sure to purge the water
line prior to hooking up the water valve.
IMPORTANT NOTE: Turn on the water supply and
check all fittings for leaks. Make certain the electrical
harness is attached to the solenoid.
In areas with water of high mineral content, the use of an
in-line water filter is recommended. Make sure the filter is
positioned and accessible for replacement when necessary.
IMPORTANT NOTE: Let your customer know that the
ice maker will not fill with water immediately, and
that the first three batches of ice produced should be
discarded. Allow 24 hours to get proper ice production.
2 0 0
S E R I E S
Step 9:
Now, level the unit. Adjust both the front and rear
levelers by turning the levelers clockwise - to raise the unit,
counterclockwise - to lower the unit. When the unit is lev-
eled properly, or squared off, door adjustments are less like-
ly to be necessary. (See Figure 3.)
IMPORTANT NOTE: Be sure to reference leveling of the
unit to the floor and not to surrounding cabinetry. This could
effect the operation of the unit, such as door(s) not closing
properly.
Step 10:
After the unit has been leveled, install the kick-
plate as shown in illustration 2.
CAUTION
Do not block the kickplate louvers with carpeting, base-
board or other materials. This will cause poor operation
or product failure.
Illus. 2
8 8
Advertisement
