Advertisement
I N S T A L L I N G P A N E L S
Before you begin installing panels, refer to the Panel
Specifications Dimensions on page 5, and be sure you are
working with the Sub-Zero panel design called for in your
installation plans. No panels or handle hardware are nec-
essary to install.
A C C O M M O D A T I O N S F O R R A I S E D
P A N E L S
You may have to rout, recess some door panel designs to
allow for finger clearance. This is particularly true if your
unit has raised panels greater than 1/4"(6) total thickness.
Check the location of offset when you're using specific rout-
ing for the grip area only. Refer to the 200 Series section of
the Sub-Zero Design Guide for additional information.
NOTE: Dimensions in parentheses are in millimeters.
2 0 0
S E R I E S
All Sub-Zero undercounter units are manufactured in a
manner to achieve a total built-in appearance.This allows
you to choose the decorative material and color application
for the front of your refrigerator/freezer. To install front
panel on all Sub-Zero undercounter models:
1)Remove door handle. Handle is located on the top on the
245 model, and on the side on other models. Handle is held
on with phillips head screws. (See illustrations 3 and 4.)
2) Slide 1/4 (6) thick panel into frame on door. Door must be
opened 90° on 245 models.If a thinner panel is used, install
chipboard filler panels behind the trim panel for proper fit.
IMPORTANT: Routing may be required on some raised
panels for finger clearance under handle.
3) With panel in position, replace handle. Replace and tight-
en all screws. Do not overtighten and "strip"screws. Refer
to pages 4 & 5 for installation dimensions. NOTE: 20# per
door panel maximum weight limit.
Illus. 3
Illus. 4
9 9
Advertisement
