Removing The Control & Power Boards & Ac Terminal Block - KitchenAid KECC586G Manual

REMOVING THE CONTROL & POWER BOARDS
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the cooktop, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
Burner Box
All manuals and user guides at all-guides.com
& AC TERMINAL BLOCK
Maintop Glass
Keyboard (Glued To
Maintop Glass)
Standoff
Control Board
Ribbon Cable
Screw
Power Board
Standoff
Screw
Figure 3-3
3-3
1. Turn off the electrical power to the cooktop.
2. Remove the cooktop from the cabinet and
set it on a padded surface to protect the
countertop.
3. Remove the maintop from the burner box
(see page 3-2 for the procedure).
Refer to Figure 3-3 for the following steps.
4. To remove the control board:
a) Disconnect the ribbon cable from the
connector.
b) Unclip the board from the standoffs and
remove it from the keyboard.
5. To remove the power board:
a) Disconnect the wires from the board
terminals.
b) Remove the two mounting screws.
c) Unclip the board from the standoffs and
remove it.
6. To remove the AC Terminal Block (see
Figure 3-4):
a) Disconnect the four wires from the ter-
minals.
b) Slide the filter board off the screws.
c) Remove the two mounting screws.
Red Wire
Mounting
Screw
AC TERMINAL BLOCK
Figure 3-4
Black Wire
Filter Board
Mounting
Screw
Black Wire
Red Wire