Removing The User Interface And Electronic Control Boards - KitchenAid KECC508MBL Technical Education

REMOVING THE USER INTERFACE AND
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Disconnect power to the cooktop.
2. Remove the cooktop glass from the burner
base (see page 4-2 for the procedure).
3. To remove the user interface board:
a) Lift the board assembly and rotate it on
its left side.
User Interface Board
ELECTRONIC CONTROL BOARDS
b) Pull the edge connector off the left side
of the user interface board and remove
the board.
c) Pull the nine springs off the posts of the
plastic light shield.
d) Unsnap the four latching tabs on the
plastic light shield from the board and
remove the board from the shield.
Latching Tab
(1 of 4)
4-4
Edge Connector
Spring (1 of 9)