Preliminary Checking Operations - APRILIA Pegaso 650 Use And Maintenance

).3425#4)/.3 &/2 53%
a
Before departure, always carry
out a preliminary checking of the
vehicle to make sure that it func-
tions correctly and safely, see the fol-
lowing table (PRELIMINARY CHECKING
OPERATIONS). The non-performance of
these checking operations can cause
severe personal injuries or damages to
the vehicle.
Do not hesitate to consult your APRILIA
Official Dealer in case there is some-
thing you do not understand about the
functioning of some controls or in case
you suspect or discover some irregular-
ities.
It does not take long to carry out a
check-up and this operation ensures
you much more safety.
02%,)-).!29 #(%#+).' /0%2!4)/.3
Component
Front and rear disc Check the functioning, the idle stroke of the control
brakes levers, the fluid level and make sure there are no leaks.
Check the wear of the pads. If necessary, top up the fluid
tank.
Accelerator Make sure that it works smoothly and that it is possible to
open and close it completely, in all steering positions.
If necessary, adjust and/or lubricate it.
Engine oil Check and/or top up if necessary.
Wheel/tyres Check the tyre surface, the inflation pressure, wear and
tear and any damage.
Brake levers Make sure that they work smoothly. If necessary, lubri-
cate the articulations and adjust the stroke.
Steering Make sure that the steering rotates smoothly, without any
clearance or slackening.
Clutch The idle stroke at the end of the clutch lever must be
about 10 mm; the clutch must operate without jerking
and/or slipping.
Side stand and Make sure that it works smoothly and that the spring ten-
&
sion brings it back to its normal position. If necessary,
center stand
lubricate joints and hinges. Make sure that the safety
switch on the side stand operates correctly.
Fastening elements Make sure that the fastening elements are not loose.
If necessary, adjust or tighten them.
Drive chain Check the slack.
Fuel tank Check the fuel level and top up, if necessary. Make sure
there are no leaks or air bubbles in the circuit.
Coolant The coolant level in the expansion tank must be included
between the "MIN" and "MAX" marks.
Lights, warning Check the proper functioning of the acoustic and visual
lights, horn and devices. Change the bulbs or intervene in case of failure.
electric devices
Check
use and maintenance Pegaso 650
Page
22-23
24-51
52
21-39-40
27
22-23-24
49
25
57
–
46-47
21-48-62
26
54÷61
29