Warranty - GRAUPNER XR -12DXT IFS Installation And Usage Manual

5.4 Keep Your Setups Simple
Although modelers love to have the latest and greatest toys, there are some products that can
introduce new potential failure points when installed. For this reason, we recommend that you
keep your setups as simple as possible. Instead of using "power expansion" type devices, we
recommend using power inputs to both ends of the Graupner|iFS-receiver's servo connection
bus.
For example, when using a Graupner|iFS-10 channel receiver, power should be connected to the
B/T port and channel 10 (even if a Y-cable, Graupner-Best.-Nr. 3936.11 is required). Using two
separate flight packs on each end of the servo bus will give you double the current capacity and
a functioning system if one pack were to fail.
5.5 Reboot Indicator
Starting with firmware version 1.3 and later, there is a reboot indicator. After connecting with the
transmitter the receiver LED will be solid red. If power is lost and restored to the receiver (a
reboot), the LED will flash slowly to indicate that a reboot has occurred. Note: if you change
batteries without turning off your transmitter, the receiver reboot indicator will occur! You must
power off the transmitter and receiver to reset this condition.
WARNING
PLEASE NOTE THAT THE PARK FLYER RECEIVERS XR-12Xx DO NOT HAVE A LOW
VOLTAGE WARNING INDICATOR, SO THE STATUS LED WILL NEVER TURN SOLID
ORANGE UNDER A LOW VOLTAGE CONDITION! PLEASE LOAD TEST THESE SETUPS TO
DETERMINE PROPER VOLTAGE!
Note:
Contains FCC ID: OUR-XBEE / OUR-XBEEPRO * The enclosed device complies with Part 15 of
the FCC Rules. Operation is subject to the following two conditions: (i.) this device may not
cause harmful interference and (ii.) this device must accept any interference received, including
interference that may cause undesired operation.
WARNING: To satisfy FCC RF exposure requirements for mobile transmitting
devices, a separation distance of 20 cm or more should be maintained
between the antenna of this device and persons during device operation. To
ensure compliance, operations at closer than this distance is not recommended.
The antenna used for this transmitter must not be co-located in conjunction with any
other antenna or transmitter.

6. WARRANTY

This product is warrantied for 24 months .
Graupner GmbH & Co. KG, Henriettenstraße 94-96, 73230 Kirchheim/Teck, Germany
guarantees this product for a period of 24 months from date of
purchase. The guarantee applies only to such material or operational defects witch are present at
the time of purchase of the product. Damage due to wear, overloading, incompetent handling or
the use of incorrect accessories is not
covered by the guarantee. The user´s legal rights and claims under guarantee are not affected
by this guarantee. Please check the product carefully for defects before you are make a claim or
Bedienungsanleitung IFS Seite 17