Installation; Button Description - Topcom SMC-1000H User Manual

4

Installation

4.1 Transportation screw
Remove the transportation screw on the backside of the product before use.
Not removing the screw can cause permanent damage to the massage cushion.
No guarantee is accepted in this case.
The massage cushion comes with a screw located on the backside of the unit to protect the massage
mechanism during shipment.
This screw must be removed before use to allow that the massager functions properly.
Properly dispose the screw and install the included black plug into the hole that was left by the screw.
4.2 Strapping system
The massage cushion can be installed to almost any chair.
Slip the straps over the seat or chair and adjust the fastening straps to secure.
The massage won't slip or slide away.
4.3 Connecting to the main power.
Only use the power adapter supplied. Do not use other adapters, as this may
damage the device.
The wall outlet for the power supply must be close and accessible.
• Plug one end of the power adaptor into the 230V outlet and the other end into the adapter jack
which leads from the massage cushion.
5

Button description

I Power button
• Press the power button to turn the unit on. The corresponding
LED light will illuminate.
• Press the power button one again to turn the unit of. The
corresponding LED will blink and the massage mechanism will
return to its lowest point before switching off.
II Full back massage
• Press this button for a full back 'Shiatsu' massage.
• All massage control LED (VI) will illuminate.
• You will enjoy a full back kneading massage
• Press this button again to switch this massage off.
III Upper back massage
• Press this button for a massage of your upper back only.
• Only the 3 upper massage control LED (VI) will illuminate.
• The massage will skip the lower bag during massage.
• Press this button again to switch the massage off.
TOPCOM SMC-1000H
TOPCOM SMC-1000H
V I I I
VII
VI
Heat Heat
I
II
III
IV
V
5