Supermicro X11DPG-OT-CPU User Manual page 11

Quick Reference Table
Jumper
JBT1
JPG1
JPME1
JWD1
Connector
BT1
CN10/CN11
COM1
FAN1-10
IPMI_LAN
LAN1/LAN2
JF1
JIPMB1
JL1
JM2-1
JNCS1
JNVI 2 C1/ JNVI 2 C2
JPW19/20, JPW 21/22
JPWR1-8, JPWR9-16
JRK1
JSDCARD1
JTPM1
JUIDB1
(I-)SATA 0-3(JS1), 4-7 (JS2)
S-SATA0
USB0
USB1/2, 3/4
VGA
LED Description
LE1 UID (Unit Identifi er) LED
LE2 Power LED
LED1 M.2 Power LED
LEDM1 BMC Heartbeat LED
Note: To avoid causing interference with other components, please be sure to use an
add-on card that is fully compliant with the PCI-standard on a PCI slot.
Description
CMOS Clear
VGA Enable
Manufacturing Mode Select
Watch Dog Timer Enable
Description
Onboard CMOS battery
x4 Oculink connectors connected to CPU2 for NVMe drive use
COM/serial port for front access
System cooling fan headers (FAN1-FAN8 ) & active CPU heatsink fan headers (FAN9/FAN10)
Dedicated IPMI LAN port
10GbE LAN Ethernet ports 1/2 on the I/O back panel
Front panel control header
4-pin System Management Bus (SMBus) I
Chassis Intrusion header
PCI-E M.2 slot
Add-on card header used for the add-on card that supports NCSI (Network Communication
Services Interface)
2
NVMe SMBus (I C) headers used for PCI-E hot-plug SMBus clock & data connections (an
SMCI-proprietary NVMe add-on card and cable are required for each NVMe SMBus header.
This feature is available for a Supermicro complete system only.)
SMCI-proprietary power supply units 19/20, 21/22 for system use
8-pin power supply connectors 1-8, 9-16
Intel RAID Key header for NVMe Solid State Device (SSD) use
BMC_SD card header
Trusted Platform Module/Port 80 connector
UID (Unit Identifi er) switch
SATA 3.0 headers with support of 8 SATA connections (JS1: SATA 0-3, JS2: SATA 4-7)
S-SATA3.0 port with power-pin built-in w/support of SuperDOM (Device-On Module)
Type A internal USB 2.0 header (USB Port 0)
Backplane Universal Serial Bus (USB) 3.0 ports 1/2, 3/4
VGA Port
11
Chapter 1: Introduction
Default Setting
Open (Normal) (See Chpt. 2)
Pins 1-2 (Enable)
Pins 1-2 (Normal)
Pins 1-2 (Reset to System)
2 C header (for an IPMI-supported card)
Status
Solid Blue: Unit identifi ed
On: Onboard power on
On: M.2 power on
Blinking Green: BMC normal