Maintenance And Cleaning; Maintenance; Checking The Adcontrol; Replacing The Adcontrol - Interroll AdControl Operating Manual

7

Maintenance and cleaning

CAUTION
Risk of injury from following incorrect procedure.
Maintenance and repair work must only be carried out by authorised and trained (specialist) personnel.
¾
Maintenance and repair work must only be carried out when the system has been disconnected from the
¾
power supply. Switch off the power to the AdControl and ensure that it cannot be unintentionally switched
on again.
Put up signs to indicate that maintenance or cleaning work is being carried out.
¾
7.1

Maintenance

Checking the AdControl

The AdControl itself requires no maintenance. However, in order to prevent faults from occurring, the connections and
fixings must be examined on a regular basis.
In the course of regular inspection and maintenance work on the conveyor, ensure that the screws of the
¾
AdControl are still tight, that the cables are still arranged correctly and that the corresponding connections are
correctly attached.

Replacing the AdControl

If a AdControl is damaged or defective, it must be replaced.
Do not attempt to open the AdControl.
Install a new AdControl (see „Decommissioning", page 34 and see „Assembling the AdControl", page 27).
¾
Version 2.0 (12/2019) Online
Translation of the original operating manual
Maintenance and cleaning
29 von 38