Locate With Locator Clamp - Leica Ultra User Manual

7.3
Procedure
Danger
Ultra, Locator Receiver Clamp

Locate with Locator Clamp

1. Plug the locator clamp cable into the accessory connector on the locator.
2. Turn on the locator. When clamp is plugged into locator, locator will enter clamp mode.
Clamp icon will show.
3. Use locator frequency key to select desired frequency. Use mode key to toggle between
active and passive power frequencies.
4. Compress the clamp handles together to open the clamp.
5. Place the clamp around the target line and release handles to close clamp.
6. Adjust the locator gain using the up and down arrow keys to bring the received signal
strength into range.
A hazardous signal may be present on the service causing personal harm.
Precautions:
Do not use on electrical services which have impaired, or no insulation. If in doubt do not
use.
68