Table of Contents
Advertisement
Procedure
Warning
Ultra, Ultra Advanced - Features
1.
On the locator menu:
Navigate to Options > Offset Depth and select Enable.
2.
Begin by holding locator parallel to line.
3.
Tilt locator until center diamond appears.
Tilt of unit should be >10° and <60° to display offset depth.
4.
Read the estimated distance.
The depth reading might not reflect the real depth if your locator picks up the signal induced
into the service by the transmitter. This signal is radiated from the centre of the service. This
is even more important when the signal is produced by a sonde, lying in a large diameter
conduit!
Precautions:
Always compensate depth reading for service size.
a
b
k
a) Diamond
b) Estimated distance
66
Advertisement
Table of Contents
