Table of Contents
Advertisement
Procedure
Ultra, Locate Active Signals
a
b
a
b
1. Facing away from the transmitter, walk in an arc approximately 25' (A, 7.5 m) around
transmitter, as shown above.
2. Rotate the locator and observe the screen.
a) Target is located where signal response is strongest. Signal strength is shown graphically
as well as numerically. The signal strength number will flash when the locator is saturated.
Reduce the gain until the number stops flashing.
b) Adjust gain as needed to maintain signal strength. Gain is shown graphically as well as
numerically.
c) The compass line shows the direction the cable runs.
e
c
f
d
56
Advertisement
Table of Contents
