Warning Label Identification; Placing Tool In Service; Specifications - Ingersoll-Rand 2080-6 Instructions Manual

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International- - No. FRL30- - C6- - A29
For USA- - No. C31- - 06- - G00
After each forty- - eight hours of operation, or as
experience indicates, inject about 4 cc of Ingersoll- - Rand
No. 170 Grease into the Grease Fitting (18).
Model Type of
Handle
2080 grip
2080- - 6 grip
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested to ISO8662- - 7

WARNING LABEL IDENTIFICATION

90 psig
(6.2bar/620kPa)

PLACING TOOL IN SERVICE

Ingersoll- - Rand No. 170

SPECIFICATIONS

Drive Impacts
per min.
in.
1" sq. dr., 875
inside trigger
1" x 6" 875
extended
sq. dr, inside
trigger
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft- - lbs (Nm) Pressure
150- - 1200
(204- - 1627)
150- - 1200
(204- - 1627)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
HSound Level
♦Vibrations
dB (A)
Power
103.8 116.8
103.8 116.8
Level
2
m/s
8.3
9.8