VESTEL AKILLI NF545 A++ Instruction Booklet page 27

LOPO
Check Warnings:
If your fridge is not operating:
• Is there a power failure?
• Is the plug connected to the socket correctly?
• Is the fuse of the socket to which the plug is connected or the main fuse blown?
• Is there any failure at the socket? To check this, plug in an appliance that you know is
working into the same socket.
If your refrigerator is operating noisily:
Normal Noises
Crackling (Ice Cracking) Noise:
• It is heard during the automatic defrosting process.
• Once the device has been cooled or heated (expansions in the device material).
Short Cracking Noise:
• Heard when the thermostat switches the compressor on/off.
Compressor Noise:
• This noise indicates that the compressor is operating normally. The compressor may
cause more noise for a short time when it is first activated.
Bubbling and burbling sound:
• This noise is caused by the flow of the refrigerant in the tubes of the system.
Water flowing sound:
• This is the normal sound of water flowing into the evaporation container during the
defrosting process. This sound may be heard during the defrosting process.
Air blowing sound:
• Normal fan noise. This noise can be heard in No-Frost fridge during the normal opera-
tion of system due to the circulation of air.
If the edges of the refrigerator cabin contacted by the door seal are hot:
Especially in summer (hot weather), the surfaces that the joint contact may get warmer dur-
ing the operation of the compressor. This is normal.
If there is humidification in the inner parts of your refrigerator:
• Is all food packed properly? Are the containers dried before placing them in the fridge?
• Are the fridge doors opened frequently? Humidity of the room gets into the fridge when
the doors are opened. Humidity build up will be faster when you open the doors more
frequently, especially if the humidity of the room is high.
This is seen when the
Low voltage power supply gets
Warning
EN - 26 -
This not a failure. This
prevents any damage
to the compressor. This
lower than
warning will clear after
the voltage reaches the
170 V.
required level.
during the normal opera-