5
Selection of the Command Set
On the PNC-3200, the first thing to do is to select the command set to use.
To perform output from the Windows program through the driver, choose "RML-1."
The driver is installed from the included Roland Software Package. For more information on how to install it, take a look at "4 Setting
Up the Software."
Selecting the Command Set on the PNC-3200
Immediately after switching on the power, use the display to choose either RML-1 or NC code. Follow the steps below to choose the
command set.
Once the command set has been selected, it can only be changed by switching the power off and on again. When you turn on the power,
the display shows the command last selected in blinking text. If you don't want to change this command, press the [ENTER] key.
1
Switch on the power.
Display screen
The operation method when performing cutting differs depending on whether you've selected RML-1 or NC code. For each respective
operation method, refer to the separate "User's Manual 2 -- Cutting Using RML-1" or "User's Manual 3 -- Cutting Using NC Codes."
18
2
Use the [ ] key to move the flashing cursor (" ") to
the command set, then press the [ENTER] key.