If You've Selected Nc Codes - Roland CAMM-3 PNC-3200 User Manual

If You've Selected NC codes

1
Press the [PAGE DOWN] key to make the following
screen appear on the display.
3
Press the [PAGE DOWN] key to make the following
screen appear on the display.
<PARA> SERIAL
5
Press the [PAGE DOWN] key once.
For serial connection
only
7
Press the [PAGE DOWN] key once, then set the data
bit in the same way.
For serial connection
only
20
PANEL I/O
SENS_MODE TIME
SELECT I/O PORT
AUTO
SELECT STOP BIT
<1> 2
SELECT DATA BIT
7 <8>
2
Press the [ ] key to move the blinking cursor (" ") to
"I/O," and then press the [ENTER] key.
PANEL
SENS_MODE
4
Press the [ ] key to move the blinking cursor (" ") to
"AUTO," and then press the [ENTER] key.
SELECT I/O PORT
PARA
6
Use the [ ] key to move the blinking cursor (" ") to
the setting value, then press the [ENTER] key.
For serial connection
only
8
Make the settings for parity, bit rate, and handshaking
in the same way.
I/O
TIME
SERIAL <AUTO>
SELECT STOP BIT
<1> 2