Transcend 365 miniCPAP User Manual page 19

Transcend 365 miniCPAP User Manual
4. Check the reservoir is at its full capacity by holding it vertically and viewing the
water level. The water should be level with the max fill line (bottom of the
reservoir seal).
Repeat steps 2 to 4 as needed to fill and check the distilled water level in the
reservoir. The reservoir should be completely filled before each use.
NOTE: The humidifier reservoir must be emptied completely before transporting
to avoid damage to the CPAP.
5. Once the reservoir is filled completely, set it on a secure, flat surface and line up
the CPAP heater cartridge
place and set the CPAP onto it so that the magnets snap the pieces together
securely.
NOTE: Be careful while inserting the heater cartridge into the reservoir so that
the reservoir seal does not get folded over, as this will generate water leaks.
with the opening in the reservoir.
Reservoir should
be filled to the
'Max Fill' line.
Line up the heater
cartridge with the
opening in the
Hold the reservoir in
Page 19
reservoir.