Power Connection Jack And Usb Port; Using The Transcend 365 Minicpap; Standard User Modes - Transcend 365 miniCPAP User Manual

Transcend 365 miniCPAP User Manual

Power Connection Jack and USB Port

Power Connection Jack
The power jack accepts the barrel plug of
the output cable from the AC power source
to operate the Transcend 365 miniCPAP.
An optional P battery pack is also
10
available to power the Transcend 365
miniCPAP.
USB Port
A mini-AB USB port is provided for direct
data exchange between the Transcend 365
miniCPAP and a computer. The Transcend
365 miniCPAP LCD screen interface allows
for basic settings adjustment and data
viewing necessary for the patient. A key
sequence allows clinicians to change
therapy settings via the LCD interface.
The USB connection allows the clinician to
configure the Transcend 365 miniCPAP for
prescription pressure, Ramp settings and
settings and also access therapy
compliance information with the Transcend
desktop software (password protected).

Using the Transcend 365 miniCPAP

Standard User Modes

Normal operation consists of four modes:
Off When the device is not connected to a power source, the device is off.
Standby When power is applied to the device the LCD screen lights up and the CPAP
enters Standby Mode. Standby Mode is also initiated by pressing the power
button when the device is in On Mode or if the mask is removed while in On
Mode. As long as power is supplied to the device it will remain in Standby
Mode until On or Drying Mode is initiated.
USB port
Page 15
Power port