Bosch MIC IP starlight 7000i Installation Manual page 48

48 en | Connections
–
–
–
2. If applicable, connect the 24 VAC wires to the power source.
3. If applicable, connect the RS-485 wires to the MIC-ALM-WAS-24 (optional).
4. Attach the ground wire from the camera to an earth-ground connection on the mounting
surface using the supplied screw or a suitable user-supplied fastener.
2019-11 | 2.1 |
If using a High PoE midspan power source:
a. Connect one end of a Cat5e/Cat6 Shielded Twisted Pair (STP) Ethernet cable to the
RJ45 connector of the camera.
b. Connect the other end of the cable to the DATA + POWER OUT port on the midspan.
Note: You must ground cable at both ends!
c. Connect a Cat5e/Cat6 Shielded Twisted Pair (STP) Ethernet cable from the DATA port
of the midspan device to the Local Area Network (LAN).
If not using High PoE: Connect a Cat5e/Cat6 Shielded Twisted Pair (STP) Ethernet cable
from the RJ45 connector of the camera to the Local Area Network (LAN).
If not using PoE and if connecting directly to a computer, DVR/NVR, or other related
network device: Connect either a Cat5e/Cat6 Shielded Twisted Pair (STP) Ethernet cable
or a crossover Ethernet cable between the RJ45 connector of the camera and the
network device. Note: You must ground cable at both ends!
Installation Manual
MIC IP starlight 7000i
Bosch Security Systems