Bosch MIC IP starlight 7000i Installation Manual page 35

MIC IP starlight 7000i
Notice!
Risk of damage to the device.
Without the yoke arm screws in position, the camera head can fall and be damaged. Hold the
head of the camera as you complete the next four (4) steps.
3. Put the screws in a safe place. You will reinstall the screws at step 6.
4. Repeat steps 2 and 3 for the second yoke arm.
5. Rotate the arms and the head assembly forward.
Notice!
Risk of damage to the device.
Do not cant the camera, or let it fall, in the wrong direction. The camera should cant only in
the direction indicated in the figure directly below.
Figure 9.4: Cant the camera head
6. Reinsert the screws into both yoke arms. Note the letter assigned to each screw in the
figure below.
Figure 9.5: Reinsert yoke arm screws (ABCD)
7. Using a torque wrench (user-supplied), tighten the screws to the proper torque using the
sequence described in the table below.
8. Recheck all four screws to ensure the proper torque value.
Do not use grease on the screws.
Bosch Security Systems
B C
D
A
Installation Manual
(Optional) Canting the Camera | en 35
2019-11 | 2.1 |