Bosch MIC IP starlight 7000i Installation Manual page 34

34 en | (Optional) Canting the Camera
Use the correct set of tools as well as the recommended torque values given in the
instructions that follow. The use of the wrong tools or torque values may cause damage to
threads or seal caps, which may result in leaks or damage to paint, which then may lead to the
start of corrosion.
Bosch strongly recommends attaching the camera to a DCA and mounting the DCA before
canting the camera.
To cant the camera, follow these steps:
1. Remove the yoke cap (item 2 in the figure below) on one yoke arm of the camera, using the
supplied spanner wrench (item 1).
Repeat for the second arm.
Figure 9.2: Remove yoke caps with spanner tool
2. Remove the two (2) screws at the bottom of one yoke arm using a wrench (user-supplied)
as described below.
Figure 9.3: Remove screws from yoke arms
2019-11 | 2.1 | Installation Manual
MIC IP starlight 7000i
Bosch Security Systems